Ch-899 Chouchin Radio Controlled Clock Manual [updated] Online
Continue holding the button to make the hands advance quickly. Release the button once you are close to the correct time, then press the button repeatedly for one-minute increments to reach the exact time.
Placing the clock near Wi-Fi routers, computers, microwaves, or television sets will jam the sensitive internal receiver. Quick Fixes for Success
Leave it undisturbed. The process takes roughly 10 minutes. If successful, the flashing icon stabilizes, and the time corrects itself. 🔍 Troubleshooting Guide 1. The Signal Icon is Missing or Flashing Continuously Severe local interference or weak signal reception.
Move the clock away from electronics (computers, routers, TVs, microwaves). Place it directly on a window sill overnight, as atomic signals travel much further through the atmosphere after dark. 2. The Clock is Exactly 1 or 2 Hours Off
The CH-899 Chouchin radio-controlled clock features a large, easy-to-read display that shows a range of information, including: ch-899 chouchin radio controlled clock manual
Press and hold the WAVE button for 3 to 5 seconds. The hands will stop moving and the clock will attempt to sync. Keep the clock near a window during this time. 3. The SET Button (Manual Time Adjustment)
Allows you to set the time manually if you live outside a signal coverage zone.
The engineering behind the CH-899 is impressive. The movement uses a unique "sweep second" mechanism, meaning the second hand moves in a smooth, continuous motion rather than ticking from one second to the next. The CH-899 is one of the most commonly used movements in modern, high-end, and designer clocks.
| Issue | Likely Cause & Solution | | :--- | :--- | | | Solution : The batteries may be dead or installed incorrectly, or the transit pin may still be in place. Check : Verify the battery polarity and that they are fresh. Make sure to remove any protective pins or tabs from the movement. | | Clock is not keeping correct time | Solution : The clock is likely not receiving the radio signal. Check : Place the clock closer to a window and away from electronics. Long-press the REC button to force a signal search. | | Second hand stops at night | Solution : This is normal. It's a battery-saving feature. The second hand will resume moving automatically at 6:00 AM. | | Cuckoo feature isn't working (if applicable) | Solution : This applies to models like the Weltbild cuckoo clock. Check : The built-in light sensor may have disabled the cuckoo because the room is dark. Try it in a well-lit room or use the ADJUST button to re-activate the cuckoo cycle. | | Clock is fast or slow by a few minutes | Solution : The quartz mechanism's initial synchronization might be off. Check : Long-press the REC button to reset the hands to 12:00 and initiate a fresh search for the time signal. | Continue holding the button to make the hands
Finding the signal can take anywhere from 3 to 12 minutes. If successful, the clock hands will quickly advance to the correct local time and begin ticking normally. Manual Time Setting
CH-899 Chouchin Radio-Controlled Clock Manual: Complete Guide and Setup The CH-899 Chouchin Radio-Controlled Clock Go to product viewer dialog for this item.
Decreases values during setup; toggles temperature units between Celsius (°C) and Fahrenheit (°F).
A: The CH-899 movement is exceptionally accurate. When it synchronizes with the atomic clock signal, it is designed to have an error of just one second in approximately 100,000 years . Quick Fixes for Success Leave it undisturbed
If the clock fails to find a signal during setup, or if you live outside a radio signal zone, you can configure the clock manually. How to Manually Set Time, Date, and Time Zone
Radio-controlled clocks offer the ultimate convenience by synchronizing automatically with atomic time signals. However, losing the physical manual for models like the CH-899 Chouchin clock can make initial setup or troubleshooting a challenge.
Atmospheric interference is lowest at night. If your clock fails to catch a signal during the day, leave it overnight near a window; it will usually update by morning.