Re-install VCOM drivers and ensure you are using a working USB cable.
The test point for the BG2-W09 is located on the mainboard, usually near the processor shielding cover. It is a tiny golden dot.
Place the second tip of the tweezers onto the (Ground). bg2-w09 test point
Only if you have soldering and phone repair experience. The bg2-w09 has a compact board with tiny components. Practice on an old device first.
: Opening picks to release the rear casing clips without scratching the frame. Re-install VCOM drivers and ensure you are using
Step-by-Step Hardware Guide to Locating and Shorting the Test Point Step 1: Disassemble the Tablet Power off the MediaPad T3 completely. Remove any micro-SD cards from the external tray slots.
A: Yes, you can try the official dload method via an SD card, but it often fails in hard-brick scenarios. Place the second tip of the tweezers onto the (Ground)
For the , the specific test point is the smaller of the two pads , often the one closer to the edge of the PCB. The other pad is usually a ground (GND) point. You short these two together.
To maintain a stable data connection during service operations. 2. Software & Drivers
Disconnect the USB cable, unplug and replug the battery, and hold the Power button to boot your revived Huawei MediaPad T3 7. Safety Precautions and Troubleshooting
Carefully remove the rear housing using a plastic pry tool.