If you can still read the card on a PC, back up the configuration files before formatting or replacing it. To help further, let me know: Is the error continuous or intermittent ? Are you using an original Kaeser card or a third-party one?
It allows service technicians to upload new firmware versions to optimize machine performance.
: Using 3rd party SD cards can lead to incompatibility issues; it is recommended to use the official Kaeser part. part number for a replacement Kaeser SD card or a guide on how to manually log on Sigma Control 2 Kaeser Compressor Fault Codes Guide | PDF | Valve - Scribd
The SD card inside the Sigma controller serves several critical functions: kaeser sd card write error top
If you ignore this error, your Kaeser unit will continue to run, but you will lose historical trend data, and in some firmware versions, the unit may experience slow boot times or fail to save parameter changes.
Use a PC and tools like the SD Card Formatter to clear potential file system errors, though this will erase all stored data. ⚠️ Common Causes Write Protection: The physical slide switch is engaged.
If your query "top" refers to physical location, ensure you check the following: Vent Valve/Back Pressure Valve : Located at the If you can still read the card on
file system. Modern SD cards often come formatted as exFAT, which the controller cannot recognize. Insufficient Memory : A minimum of
While the Kaeser SD card write error can be a significant issue, the troubleshooting steps and preventative measures outlined in this review can help minimize downtime and ensure optimal performance. With proper maintenance and care, your Kaeser compressor's control system should operate reliably and efficiently.
Open the card properties to check the file system. It must be or FAT16 . It allows service technicians to upload new firmware
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The physical write-protect switch on the SD card is active.
If it is formatted as NTFS or exFAT, backup any existing files and reformat the card to FAT32.
[Inspect Physical Lock] ──> [Clean Contacts] ──> [Verify File System & Size] ──> [Format to FAT16/32] ──> [Test/Replace Card] Step 1: Check the Physical Lock
Perform a (do not use NTFS or exFAT unless explicitly dictated by your specific firmware version). Reinsert the card into the unpowered controller slot. 3. Replace the Card with Industrial-Grade Media