Corrupted eMMC firmware, corrupted SPI flash, or missing secondary voltage rail. Fix:
The factory configuration screen will overlay on top of the image. Use caution when modifying parameters here, as incorrect LVDS voltage settings can permanently damage an attached screen panel. Finding and Downloading the Schematic PDF
Corrupted software is the primary cause, followed by degraded filtering capacitors on the 5V or 1.1V core rails. Inspect capacitors for bulging tops or high ESR (Equivalent Series Resistance). 3. Audio Distortion or No Sound
A reputable source for free, community-uploaded repair manuals and schematics.
The TP.MS3458.PC757 is a widely used triple-network smart LED TV mainboard. It integrates the power supply unit (PSU), LED backlight driver, and ATV/DTV motherboard into a single printed circuit board (PCB). This design is highly cost-effective for manufacturers but requires specific troubleshooting steps when a component fails. Technical Specifications and Architecture tp.ms3458.pc757 service manual
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Factory settings often drive the LEDs at maximum current, causing premature burnout. To lower the backlight current and extend the life of new LED strips, locate the current-sensing resistor bank connected to the source of the LED driver low-side MOSFET. Remove one or two high-resistance parallel surface-mount (SMD) resistors (e.g., 1R0 or 2R2). This increases the overall feedback resistance and safely lowers the output current. 4. Troubleshooting Flowchart & Common Symptoms Symptom 1: Dead / No Power / No Standby LED
Turn on the main AC power switch while continuing to hold the power button.
Test Point: Small inductor closest to the main heatsink/SoC. Corrupted eMMC firmware, corrupted SPI flash, or missing
Test Point: Dedicated buck regulator inductor near the RAM/SoC grouping. 3. The Backlight Circuit (LED Driver)
Check the voltage at the LED backlight connector. If the voltage spikes up to ~140V upon turning on the TV and then drops back down to 12V, the board's over-voltage protection (OVP) is triggering because an LED strip inside the panel is open-circuit. If the voltage never rises above 12V, the backlight driver IC on the board is faulty. Firmware Flashing and Service Menu Access
The TP.MS3458.PC757 Go to product viewer dialog for this item.
Handles processing, UI, inputs, and outputs. Finding and Downloading the Schematic PDF Corrupted software
If the TV is completely dead or stuck in standby (red light only), you must open the chassis and probe the mainboard test points using a digital multimeter set to DC voltage.
Generates high-frequency pulses to drive the main transformer. 2. The Cold Side (Low Voltage)
If the primary code does not work, try these alternatives:
