Write down all changed parameters before exiting.
RS-485 data lines for communication with the Challenger panel. Request to Exit (RTE) input for controlling door egress. OUT (Open Collector) A 50mA output used to drive a door relay or door strike.
Every device on a Challenger RS-485 LAN requires a unique target address to communicate properly. Configure the DIP switches on the rear of the prior to powering on the system.
Drive the mounting screws firmly through the bracket into the wall anchors.
: Use the standard Challenger LAN terminals (+, –, D+, D-). For runs over 100 meters, a separate 12V power supply is recommended. Inputs/Outputs : The TS1162 includes a Request to Exit (RTE) input and one open collector output for controlling door relays or strikes. Addressing & Configuration RAS address using the internal DIP switches (typically switches 1–4). ts1162 installation manual
Access the configuration menu via the onboard display or the connected software utility.
If your unit features a digital display or network interface, follow the on-screen prompts to set your language, time zone, and system parameters. 6. Maintenance and Troubleshooting
Installation for the IBM TS1162 drive generally occurs within a tape library like the TS4300 or TS4500. Installation Steps Tecom TS1162 3 LED RAS - Ness Corporation
Handle the TS1162 package with care to avoid damaging sensitive internal components. Write down all changed parameters before exiting
: Can be installed up to 1.5 km from the main Challenger panel or Intelligent Access Controller. Inputs/Outputs : One input for Request to Exit (RTE) control.
is a robust remote arming station for Challenger security systems. aritech.com.au Installation Highlights: Connectivity:
You're looking for the installation manual for the TS1162!
Hold the mounting bracket against the wall at the desired height. OUT (Open Collector) A 50mA output used to
The Challenger system identifies each keypad by its unique RAS address, which must be set manually before the unit is powered up.
: Never assign the same address number to two different keypads or modules sharing the same physical LAN bus. System Commissioning and Testing
How to set up the gravity drain or optional condensate pump. Electrical Requirements: