: While keeping the pins bridged, plug in the power. You should hear a beep .
Connect your computer directly to the device using an Ethernet cable.
Once the factory reset finishes, your customized Wi-Fi network name (SSID) will disappear. It reverts back to the default factory network name. Reconnecting to the Gateway
– Go to your ISP’s support portal (e.g., Telmex, Prodigy, Infinitum). Search for 7004TLMV3 firmware .
If none of these steps work, contact technical support, as there may be a hardware issue. 7004tlmv3 password reset
: Look for a tiny, recessed button on the back panel labeled Reset .
If the camera was previously configured, you may need to re-IP it to match your network subnet.
Open the camera casing if it is a dome camera, or look for a small button on the cabling. Power On: Keep the camera connected to power.
Insert the tool into the hole. Press and hold the button down firmly for 10 to 15 seconds. : While keeping the pins bridged, plug in the power
The login screen will appear. Enter the default username and password (e.g., admin / leave password blank).
Enter the default username admin and leave the password field completely empty.
: Power down the unit and remove the outer cover to access the motherboard.
: Watch the status lights on the front panel. They will rapidly blink, turn solid amber, or shut off briefly to acknowledge the command. Once the factory reset finishes, your customized Wi-Fi
Try the following combinations used by major ISPs for Arris hardware:
– Use a paperclip, a SIM ejector tool, or a thin, unbent pen tip.
After a successful factory reset, the 7004tlmv3 will have lost all previous configurations. This means:
If the software method fails, you can force a date reset, which often reverts the password to a default or known temporary state. : Disconnect the power and open the DVR casing.