Harvey Hv3 Water Softener Installation Manual |top| Guide

After a few minutes, close the kitchen tap and thoroughly check all pipework for leaks.

Locate your main water stopcock and turn it off completely. This isolates the water supply to your property. Open a cold water tap downstairs to drain residual water from the pipes and relieve pressure in the system.

Harvey HV3 is a non-electric, twin-tank water softener designed for block salt use. Installing this unit involves four primary connections—inlet, outlet, drain, and overflow—and requires adherence to local plumbing regulations and WRAS guidelines Pre-Installation Requirements WATER SOFTENER INSTALLATION GUIDE harvey hv3 water softener installation manual

If you need help with a specific part of the installation process, please tell me: Your (copper, plastic, etc.)

After installation, use a water hardness test kit on your kitchen tap. The reading should be . Note that your hot water cylinder may take several days to transition from hard to soft water as the existing scale begins to dissolve. Troubleshooting Tips After a few minutes, close the kitchen tap

What type of do you have (e.g., combi-boiler, unvented, gravity-fed)?

The Harvey HV3 water softener installation manual dedicates an entire section to pre-installation planning. Do not skip this page. Here is what you need to confirm: Open a cold water tap downstairs to drain

The requires very little maintenance, focusing mostly on salt replenishment. Salt Type: Use Harvey Block Salt.

Open the top lid of the Harvey HV3 and place two blocks of Harvey water softener salt into the loading compartments.

: Use WRAS-approved flexible hoses for the inlet and outlet. Remove the red protective caps from the softener before connecting. Drain & Overflow :

The manual also contains a QR code (or URL) to download a maintenance log sheet and a video guide for seal replacement.