Thyssenkrupp Levant Stair Lift Installation Manual Full ((exclusive)) (SECURE × Walkthrough)

Two wireless remote control handsets and the armrest control switch.

The Levant operates on a 24V DC battery system that charges automatically at the top and bottom of the run.

Routine maintenance checklist (monthly/quarterly):

The full is not publicly available. Certified installers can access the latest revision via the ThyssenKrupp Access Dealer Portal after passing annual recertification. Updates typically address rail material tolerances (since 2021 models use extruded 6063-T5 aluminum) and software flashing procedures for the Levant’s CAN-bus controller. thyssenkrupp levant stair lift installation manual full

Slide the floor mounting brackets (feet) into the tracks on the underside of the rail.

Attach the seat assembly to the carriage. The Levant manual will detail the specific bolts and safety mechanism for attaching the seat to the carriage.

If the two wireless remote controls do not actuate the lift out of the box, they must be paired manually: Two wireless remote control handsets and the armrest

Before unboxing the components, you must prepare the installation environment and gather the necessary tools. Required Tools

Push the second rail section firmly against the first, ensuring the gear racks align perfectly. A gap in the gear rack will cause the carriage to stall or jump.

Plug the wall transformer into the structural electrical outlet. Step 7: Commissioning, Testing, and Calibration Initial Movement Test Certified installers can access the latest revision via

Before unboxing the Levant stair lift components, you must assess the staircase configuration and gather the correct tools. Spatial Requirements

Drill pilot holes using a 4mm wood bit. Secure the brackets using the provided heavy-duty wood lag screws.

Contains the motorized drive unit, batteries, main circuit board, and internal chassis.

Press and hold the programming button on the main carriage circuit board until an LED begins to flash.