Ivoclar Programat P100 Manual English !link! -

: Never open the furnace head by hand; use the electronic controls to avoid damaging the lift mechanism. Energy Efficiency

Clear the area around the furnace head. Check for mechanical blockages. Temperature error / Thermocouple failure.

When the Programat P100 encounters an operational fault, it displays a specific error code. Error Code Potential Cause Recommended Action Heating muffle failure or broken thermocouple.

Check the muffle resistance; replace the heating element or thermocouple. Vacuum failure (cannot reach target pressure). ivoclar programat p100 manual english

: To prevent moisture from damaging the heating muffle, the furnace head should remain closed when the device is powered off. Cleaning Programs

Are you looking to (e.g., porcelain-fused-to-metal, low-fusing glass)?

The manual includes a troubleshooting guide for common error messages. Common issues addressed include: : Never open the furnace head by hand;

To ensure consistent results, regular maintenance is required.

The Programat P100 utilizes a thermocouple to monitor chamber temperatures. Over time, this sensor can drift. Perform a silver wire calibration every six months: Obtain a certified Ivoclar silver calibration wire. Place the wire on a firing tray inside the chamber.

Ensure the device is placed on a stable, heat-resistant surface. Always ensure the vacuum pump is correctly connected via the vacuum hose before starting a firing cycle that requires vacuum. Temperature error / Thermocouple failure

The manual describes a “Factory Reset” under the service menu. Typically: Power off > Press and hold the “Program” and “Up Arrow” keys > Power on > Select “F-Def” > Confirm. This erases all custom programs.

The heating element may be cracked or burnt out. Requires muffle replacement.

Socket on the back for connecting the necessary vacuum pump. 4. Operating the Programat P100