Wash with plenty of water. Remove contaminated clothing immediately.
, an environmentally friendly epoxy resin coating manufactured by . Product Overview Nitocote NT402
The coal tar component provides the material’s signature resistance to seawater and acid, but it is also the primary focus of safety regulations due to its chemical complexity.
Can cause skin irritation and potential sensitization. It can be absorbed through the skin. Eye Contact: Causes serious eye irritation. nitocote nt402 msds
A: The technical data sheet does not explicitly mention potable water approval. Specific advice must be sought from Fosroc for potable water exposure.
There are several ways to access the Nitocote NT402 MSDS:
The Nitocote NT402 MSDS is essential for several reasons: Wash with plenty of water
| Property | Value / Specification | | :--- | :--- | | | Light Grey, Dark Grey, Black, Brick Red, Sage Green | | Solid Content | 100% | | Specific Gravity | 1.35 g/cm³ at 23°C | | Pot Life (Working Time) | 25 minutes at 23°C; 13 minutes at 35°C | | Tack Free Time | 2-3 hours at 23°C; 1-1.5 hours at 35°C | | Overcoating Interval | 6-8 hours at 23°C; 3-4 hours at 35°C | | Full Cure | 4 days at 23°C; 2 days at 35°C | | Abrasion Resistance | 0.22g weight loss (ASTM D4060, 1000 cycles) | | Adhesion Strength | 2.0 N/mm² (ASTM D4541) | | Water Absorption | Nil after immersion; 0.1% after boiling (ASTM C642) | | Coverage Rate | Approx. 5.0 m²/litre per coat @ 200 microns WFT (Theoretical) |
| Property | Value | |----------|-------| | Appearance | Viscous liquid | | Odor | Slight amine-like (Part B) | | pH (mixed) | ~9–10 (alkaline) | | Viscosity (mixed) | 750–1000 cP | | Density | ~1.10–1.20 g/cm³ | | Solubility in water | Miscible (water-based system) | | VOC content | <50 g/L (low VOC) |
Splashing the product into the eyes can cause severe irritation, pain, and potentially permanent damage if not rinsed immediately. Product Overview Nitocote NT402 The coal tar component
– A powerful aliphatic amine cross-linker responsible for hard chemical resistance but highly sensitizing to human tissue. 2. Hazard Identification and Signal Words
Nitocote NT402 is supplied in a two-component pack consisting of a and a Hardener , which must be mixed in exact proportions prior to application. Both components have distinct chemical makeups and, consequently, unique safety profiles. 1. The Base Component
This section provides the official trade name.It lists the manufacturer details and emergency contacts.Always call these numbers during chemical spills. 2. Hazards Identification
45 minutes (Reduced to approx. 20-25 mins at 35°C). Tack-free Time: 2 to 3 hours at 23°C. Overcoating Time: 6-8 hours at 23°C. Full Cure: 4 days at 23°C. Adhesion Strength: 2.0 N/mm².
: High risk of permanent skin sensitization if handled with bare skin. 3. Hazardous Composition Profiles