Jump to content

Gunnebo Speedstile Fl Installation Manual Online

The speed gate must fail-safe open during an emergency.

: The foundation must be a flat, level concrete base with a minimum resistance of fck(cube) 30N/mm² .

Once structural and electrical installations are complete, proceed with system configuration. Initial Power-Up

Clean all IR sensor lenses along the side walls with a lint-free microfiber cloth. gunnebo speedstile fl installation manual

Once the floor is prepared, the cabinets can be positioned and secured. Positioning the Cabinets

25 mm diameter for access control integration, Ethernet, and fire alarm loops.

Inspect the glass leaf clamping mechanisms for signs of loosening or friction wear. The speed gate must fail-safe open during an emergency

Contains the primary logic controller, power supply unit (PSU), and motor drive.

Installing a SpeedStile FL is an exercise in systems thinking: the piece parts—glass, motor, sensors, readers—are simple enough alone, but they must be assembled into a human-centered system. The installer’s craft is in aligning tolerances, wiring logic to human behavior, and anticipating failure modes so the turnstile feels effortless to users and manageable to operators. When installed with care, the SpeedStile FL vanishes into the building’s flow, delivering security without friction.

: The floor must be level within +/- 5mm over the entire footprint. Initial Power-Up Clean all IR sensor lenses along

Contains user keys, configuration software (if ordered), and physical layout templates. 3. Physical Installation Step-by-Step Step 1: Marking the Footprint Clear the installation zone of all debris.

Standby consumption is approximately 30VA; peak consumption during leaf movement reaches up to 250VA per lane.

Regular maintenance is essential for longevity. The Gunnebo SpeedStile FL is built for durability, with an average of , supported by an external toothed braking mechanism for robust locking.

Each master cabinet requires an independent single-phase power supply protected by a circuit breaker.

×
×
  • Create New...