Gpsuinet Setup Best _hot_

Avoid placing the antenna near large reflective surfaces like metal roofs or glass facades, which bounce signals and cause timing errors. Tackle Signal Attenuation

Go to the "PTP Settings" tab.

Before configuring software, your hardware must meet the operational constraints of the device.

: In your networking software or telemetry dashboard, input the credentials for a regional NTRIP caster network. gpsuinet setup best

Your GPSUINet software should display:

| Component | Best Practice Setting | | :--- | :--- | | | Dual-band, clear sky, <30m cable, surge protected | | Switch | IEEE 1588v2, Transparent Clock mode, Industrial grade | | PoE | 802.3bt (60W per port) | | IP Strategy | Static IPs ( 10.10.10.x/24 ) | | Timing | Sync interval 125ms, Domain 24, E2E delay | | QoS | DSCP 46 (Expedited Forwarding) | | VLAN | Dedicated ID 999, isolated from data traffic | | Redundancy | Dual Grandmasters, RSTP ring topology, Pure sine UPS | | Monitoring | Check DOP < 1.5, Time offset ±100ns daily |

To get the most out of your setup, refine the following operational settings: Avoid placing the antenna near large reflective surfaces

: Access the Admin Panel (usually at 192.168.8.1 ) to complete the initial wizard.

Never run GPSUINet Ethernet cables parallel to motor drives or VFDs (Variable Frequency Drives) inside the same conduit.

Do not put GPSUINet on the same VLAN as office Wi-Fi or security cameras. : In your networking software or telemetry dashboard,

Appendix A: Sample systemd unit for gpsuinet Appendix B: NMEA sentence reference card

Purchase two GPS timing receivers.

: For mobile devices or tablets acting as interfaces, ensure the location mode is set to "High Accuracy" to utilize GPS, Wi-Fi, and mobile networks simultaneously. 4. Best Practices Summary Best Action Use a multi-band L1/L2 antenna for better signal locking.