Zte F689 Bridge Mode [2021] -

Check if your Internet Service Provider (ISP) uses PPPoE or DHCP (Dynamic IP) . If they use PPPoE, make sure you have your internet username and password handy. You will need to enter these into your new router later.

Open a web browser and type http://192.168.1.1 into the address bar, then press Enter. Enter the administrator credentials.

Plug one end of an Ethernet cable into your computer and the other end into a (preferably LAN1) on the ZTE F689.

If your ISP uses , select Dynamic IP . Your router should pull the public IP immediately.

To avoid wireless interference and IP assignment conflicts, turn off the gateway's routing remnants. Navigate to > WLAN > WLAN Basic . Zte F689 Bridge Mode

Log into your new router's setup page using its mobile app or default IP address.

After the restart, the ZTE F689 will act as a pure modem. You will no longer be able to access its web interface using the default IP address until you reset it to factory settings.

Check that you are connected to the correct LAN port on the F689. Verify your PPPoE credentials in your personal router.

Select the specific (usually LAN1) to bind to this bridge. Save & Reboot: Apply changes and restart the device. ⚠️ Common Hurdles Check if your Internet Service Provider (ISP) uses

Running two routers creates two layers of Network Address Translation (NAT). This often causes issues with online gaming, VPN connections, and smart home devices. Bridge mode solves this instantly.

Ensure the settings match what you wrote down in Step 2. If your ISP handles VLAN tagging on their end, leave it disabled. Click Save or Apply . Option B: Creating a New Bridge Profile

If you need help configuring your specific setup, please let me know , the brand and model of your external router , and whether you use extra services like IPTV or VoIP landlines . Share public link

Depending on the specific firmware version loaded by your ISP, you will either modify the existing profile or create a new one. Method A: Modifying the Existing Profile Open a web browser and type http://192

If there is no obvious bridge mode toggle, your ISP may have hidden the option. A widely used workaround involves using your browser's "Inspect Element" tool to unhide the "Bridge" option within the WAN settings.

Before altering your network architecture, gather the following essential details and equipment:

: Open a web browser and enter the modem's IP address (commonly 192.168.1.1 192.168.20.1