Use conductor cross-sections between 0.2 and 4.0 mm² (AWG 22–12) for solid wire.
The official Moeller (now Eaton) software is free and provides a Windows-based drag-and-drop environment.
The easy512-AC-RC utilizes a simplified Ladder Diagram (LD) logic interface. The built-in LCD displays a grid where you construct your control circuit block by block. Logic Matrix Structure
Press ESC to leave the edit mode and select "RUN" to start the program. 4. Using EasySoft Programming Software
: 4 channels (Relay outputs, 8 A continuous current capacity) Display : Built-in LCD screen with 4 lines x 12 characters Keypad : 8 operational keys for direct on-device programming Environmental Limits Operating Temperature : -25°C to 55°C moeller easy512-ac-rc programming manual
: Check for electrical noise; check your pulldown resistor if using sensors 1.2.1.
Keeps an output on for a set duration after the trigger drops. Flashing (Z): Cycles an output on and off at set intervals.
4 up/down counters with configurable setpoints.
: Drag-and-drop inputs, coils, timers, and counters. Use conductor cross-sections between 0
, operating on a 100–240 VAC supply. Programming can be done directly on the device using its integrated LCD display and key pad or via the easySoft-Basic software Control Parts Core Programming Features Klockner Moeller EASY 512 Programming Instructions
The interface is menu-driven. Pressing usually brings up the main menu structure.
Toggle between Normally Open (NO) and Normally Closed (NC) states by highlighting the component and pressing the Left/Right arrows.
Wait—analog? Yes. Inputs I7 and I8 on the AC version can function as 0-10V analog inputs (not just 230V AC digital). This allows you to read a potentiometer, temperature sensor, or pressure transducer. The built-in LCD displays a grid where you
The Moeller Easy512-AC-RC programming manual highlights several key features and functions, including:
: Via front panel buttons or Eaton EasySoft Pro software. Capacity : Up to 128 rungs of ladder logic. 2. Wiring the Easy512-AC-RC Proper wiring is essential to prevent damaging the unit. Power Supply ( terminals) : Connect to the terminals marked Input Wiring ( I1cap I sub 1 I8cap I sub 8 ) : The inputs are
Before any installation work, the device must be completely de-energized. Ensure protection against unintentional reconnection and verify the absence of voltage. Mounting:
The device supports a wide range of standard and advanced functions: