Eppendorf 5402 Manual Updated ((full)) Jun 2026

Always load the rotor symmetrically to prevent imbalance, which can cause severe mechanical damage.

Error 3: No rotor detected. Solution is to insert the rotor. Acme Revival Centrifuge 5420 - Eppendorf

Adjustable from 0 to 14,000 RPM in 100 RPM increments. Maximum RCF: Up to Temperature Control: A broad cooling range from -9∘Cnegative 9 raised to the composed with power C 40∘C40 raised to the composed with power C

?

Because the 5402 is a legacy instrument, official support from Eppendorf may be restricted to legacy documentation. However, third-party laboratory equipment refurbishers and parts suppliers regularly stock updated components:

The Eppendorf 5402 is backed by a comprehensive warranty and dedicated customer support team. For more information, please visit the Eppendorf website or consult the manufacturer's customer support team.

Maintain a clearance safety zone of at least 30 cm (12 inches) around the entire unit. eppendorf 5402 manual updated

Heads up to anyone maintaining an Eppendorf 5402! 🛠️

For temperature-sensitive work, use the function. This feature can cool the rotor chamber from ambient room temperature down to 4°C in approximately 10 minutes . 2. Loading the Rotor EPPENDORF - 5402 Refrigerated Microcentrifuge - LabWrench

For brief, rapid spins. The centrifuge runs at maximum speed as long as the key is held down. Always load the rotor symmetrically to prevent imbalance,

Error codes can appear for a variety of reasons. Consulting the manual is essential for an accurate diagnosis, but here is a table of common error codes based on community and forum discussions.

1 to 99 minutes, or continuous operation (Hold) 2. Installation and Safety Protocols Proper Placement

Do not operate the unit in direct sunlight or in rooms exceeding 40°C. Electrical Requirements Acme Revival Centrifuge 5420 - Eppendorf Adjustable from

Clean the rotor chamber with a mild detergent or a 70% isopropyl alcohol solution at the end of every day. Avoid harsh bleach mixtures that can pit the stainless steel.